Product ID:SHELL TURBO(R) OIL 78
MSDS Date:04/05/1991
FSC:9150
NIIN:01-263-7240
MSDS Number: CDJSX

Emergency Phone: 713-473-9461/800-424-9300(CHEMTREC)

Info Phone: 713-241-4819/4141/2252 FAX -6511

Preparer: J.C.WILLETT

Cage: 54527

Telephone: 800-231-6950

Cage: 54527

SOL REF HYDROTREATED HEAVY PARAFFINIC DIST

CAS: 64742-54-7

RTECS: PY8035501

Fraction By Weight: 99%

MINOR ADDITIVES

Fraction By Weight: <1%

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:SKIN:LUB OILS GENERALLY CONSIDERED TO
BE NO MORE THAN SLIGHTLY IRRIT.PROL/REP CONTACT MAY RESULT IN SKIN
DISORDERS(DERM,OIL ACNE,FOLLICULITIS).ACCIDENTAL RELASE UNDER HI
PRESSURE APPLICATIONS MAY RESU LT OIL INJECTION INTO SKIN CAUSING
LOC NECROSIS.INHAL:VAP(FROM HI TEMP ONLY)/MIST MAY CAUSE MILD IRRIT
UPPER RESP(SUPPL)
Explanation of Carcinogenicity:PER MSDS:PROD/COMPO NOT CLASSIFIED AS
CARC BY IART/NTP/OSHA.
Effects of Overexposure:MINIMALLY EYE IRRIT,SLIGHTLY IRRIT TO
SKIN,IRRIT UPPER RESP TRACT.NECROSIS MAY BE EVIDENCED BY DELAYED
ONSET OF PAIN & TISSUE DMG A FEW HRS FOLLOWING HIGH PRESSURE
INJECTION.
Medical Cond Aggravated by Exposure:PRE-EXISTING SKIN & RESPIRATORY
DISORDERS MAY BE ASGGRAVATED BY EXPO TO THIS PRODUCT.

First Aid:EYE:FLUSH W/WATER FOR 15MINS WHILE HOLDING EYELIDS OPEN.GET
MED ATTN.SKIN:REMOVE CONTAMIN CLOTH.WIPE EXCESS OFF.WASH
W/SOAP/WATER OR WATERLESS HD CLNR FOLLOWED BY SOAP/WATER.IRRIT
OCCURS GET MED ATTN. MATL INJECTED UNDER SKIN GET MED ATTN PROMPTLY
TO PREVENT SER DMG.DON'T WAIT FOR SYMPT TO DEVELOP.INHAL:REMOVE TO
FRESH AIR.BREATH DIFF GIVE OXY.GET MED ATTN.INGEST:DON'T INDUCE
VOMIT.IN GENERAL(SUPP)

Flash Point Method:PMCC
Flash Point:416F,213C
Autoignition Temp:Autoignition Temp Text:NP
Lower Limits:N/AV
Upper Limits:N/AV
Extinguishing Media:USE WATERFOG,FOAM,DRY CHEMICAL,CO2.DON'T USE DIRECT
STREAM OF WATER.PROD WILL FLOAT,CAN BE REIGN ON SURFACE OF WATER.
Fire Fighting Procedures:WON'T BURN UNLESS PREHEATED.DON'T ENTER
CONFINED FIRE SPACE W/OUT FULL BUNKER GEAR(HELMET W/FCSHIELD,BUNKER
COAT,GLOVE,RUBB BOOT),+PRESSURE NIOSH APPROV SCBA.
Unusual Fire/Explosion Hazard:COOL FIRE EXPO CNTNR W/WATER.

Spill Release Procedures:MAY BURN ALTHOU NOT READILY IGN.USE CAUT
JUDGEMENT WHEN CLEANING UP LG SPILLS.LG:WEAR RESP/PPE AS
APPROPRIATE.SHUT OFF W/O RISK.DIKE/CONTAIN.REMOVE W/VAC TRUCKS/PUMP
TO STOR/SAL VESS.SOAK RESIDUE W/AB SORBENT(CLAY,SAND,SUITABLE
MATL).DISPO (SEE PRECA)

Handling and Storage Precautions:MIN SKIN CONTACT.STORE IN COOL DRY
PLACE W/ADQUATE VENTILATION.KEEP AWAY FROM OPEN FLAMES/HIGH TEMPS.
Other Precautions:SPILL:PROPERLY.FLUSH AREA W/WATER TO REMOVE TRACE
RESIDUE.MS:TAKE UP W/ABSORBENT MATL.DISPO PROPERLY. BE SAFE:READ
PRODUCT SAFETY INFO & PASS IT ON.

Respiratory Protection:EXPO MAY/DOES EXCEED OCCUPATIONAL EXPO LIMITS
USE NIOSH-APPROVED RESP TO PREVENT OVEREXPO.IAW 29CFR1910.134 USE
EITHER ATM-SUPPLYING RESP OR AIR-PRUIFYING RESP FOR ORG
VAP/PARTICULATES.
Ventilation:USE W/ADEQUATE VENTILATION.
Protective Gloves:CHEM RESIST GLOVES (NITRILE).
Eye Protection:SAF GOGGLES.
Other Protective Equipment:PROTECTIVE CLOTHING(NITRILE) AS REQUIRED TO
MIN SKIN CONTACT.
Work Hygienic Practices:WASH W/SOAP/WATER BEF EAT/DRINK/SMOKE/TOIL
USE.WASH CONTAM CLOTH BEF REUSE;PROPERLY DISPO UNABLE TO DECONTAM
LEATHER ITE
Supplemental Safety and Health
HEALTH:TRACT.INGEST:GENERALLY CONSIDERED NO MORE THAN SLIGHTLY TOXIC IF
INGEST. 1STAID:NO TREATMENT NECESSARY UNLESS LG AMT OF PROD
INGEST.HOWEVER GET MED ADVICE.NOTE TO DR:IN GENERAL EMESIS
INDUCTION UNNECESSARY IN HI VISC,LOW VOLATI PROD(MOST
OILS,GREASES). DISPO:PLACE IN APPROP DISPO FACI IAW LOC REGS.

HCC:V6
Boiling Pt:B.P. Text:N/AVAI
Melt/Freeze Pt:M.P/F.P Text:10F,-12C PP
Decomp Temp:Decomp Text:NP
Vapor Pres:N/AVAI
Vapor Density:N/AVAI
Spec Gravity:0.8805
pH:NP
Viscosity:75CS @40C
Evaporation Rate & Reference:N/AVAI
Solubility in Water:NEGLIGIBLE.
Appearance and Odor:PALE YELLOW OIL, SLIGHT HYDROCARBON ODOR.
Percent Volatiles by Volume:NP
Corrosion Rate:NP

Stability Indicator/Materials to Avoid:YES
OXIDIZING MATLS.
Stability Condition to Avoid:AVOID HEAT, OPEN FLAMES, OXIDIZING MATLS.
Hazardous Decomposition Products:HIGHLY DEPENDENT ON COMBUST
CONDITIONS.COMPLEX MIXTURES:AIRBORNE SOLID,LIQ,PART,GAS WHEN
PYRO/COMBUST.CO,UNID ORG CMPDS.

Waste Disposal Methods:BASED ON INFO AVAI TO SHELL PROD DOESN'T CONTAIN
ANY CHEM LISTED ON CHEM SPEC STATE LIST NOR REG BY SARA TITLE
III.PROD CLASSIFIED AS OIL PER 311 CWA.SPILLS ENTER:SURFACE
H2O/H2OCOURSE/SEWER ENTER/LEA D TO SURF H2O CAUSE SHEEN;REPORT
800-424-8802(SUP)

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.